I have been running an XR for a while now but recently got my Bully back. Shortly after that i got sponsored my RC4WD and them the motor in my XR crapped out. So i have been driving the Bully again and i have to say i have missed it. It is so consistent and indestructible. So thought i would but my build thread up in here. I am running the light weight axles with heavy tubes in front. I like it like this because i only have to run 3oz in the front wheels.
It will have 2 fxr's soon but for now....
1 fxr
punk dig
Hitec 7950
integy 45t's
CKRC Droid chassis
SCX10 plastic schocks
1" SLW's 750 front/600's rear
--5lb 5oz RTR--
The front axle is clocked. Not sure how much, i just eyeballed the holes with a hand drill I ground out the "C" and knuckle to get as much cleance as possible. I am very close to the same as 300's.
I've done a little work to the rear axle! Tubes are turned down to 11.5 mm, cases are ground and the tops are cut off. The shock mount is cut off the link mount and a new hole was drilled as close to the link hole as would clear. The upper link mount was cut as short as i could get it also.
It will have 2 fxr's soon but for now....
1 fxr
punk dig
Hitec 7950
integy 45t's
CKRC Droid chassis
SCX10 plastic schocks
1" SLW's 750 front/600's rear
--5lb 5oz RTR--
The front axle is clocked. Not sure how much, i just eyeballed the holes with a hand drill I ground out the "C" and knuckle to get as much cleance as possible. I am very close to the same as 300's.
I've done a little work to the rear axle! Tubes are turned down to 11.5 mm, cases are ground and the tops are cut off. The shock mount is cut off the link mount and a new hole was drilled as close to the link hole as would clear. The upper link mount was cut as short as i could get it also.
Comment